INSTALLATION PLANNING • MODELS RMDD3004EX, RMDD3604EX, RMDD4804EX
DIMENSIONS
NOTE:Dimensions shown are for reference only.Before cutting out countertop, refer to instructions packed with downdraft and cooktop.
*
*
*Dimensioned from top of countertop
TYPICAL INSTALLATION
COUNTER | CHIMNEY TOP | ||
TOP | |||
| |||
| COOK TOP |
| |
|
| ||
|
|
| |
DOWNDRAFT
A | 1 3/4 " |
| |
| 2" |
COUNTER TOP
COOKTOP | B |
DOWNDRAFT
FRONT TO BACK
INSIDE CABINET DEPTH
Refer to the cooktop installation instructions for dimensions of cooktop, countertop
Cooktop depth can vary greatly from one to another. This may cause the fit of these two appliances to be rather tight.
Pay special attention to the 4 areas of potential interference highlighted above. A countertop with (A) a raised lip and/or (B) a backsplash, may not allow enough flat countertop for a proper installation. The back of the downdraft
DUCTWORK
This downdraft blower system is designed for use with 3¼" x 14" rectangular ductwork (can be transitioned to 8" or 10" round).The blower discharge can be positioned in one of 3 directions with 7½" movement side to side.
CABINET FRONT
GEAR
MOTOR
COVER
BLOWER |
BOX |
AIR
VENT
120VAC
GOUNDED OUTLET
|
| RIGHT |
|
| DISCHARGE |
LEFT |
|
|
DISCHARGE |
| DOWN |
|
| |
|
| DISCHARGE |
|
| (as shipped) |
|
|
|
3¼" x 14" TO | 3¼" X 14" | 8" RD. |
8" RD. | 90o ELBOW | ELBOW |
TRANSITION |
|
|
DUCT CONNECTOR
ELECTRICAL
The unit has an
5 FT. | 19 FT. | 11 FT. |
The system will operate most efficiently when the ductwork does not exceed 40 feet of equivalent duct. The chart above, shows equivalent feet of elbows and transitions. The number of feet of straight 3¼" x 14" or 8" duct plus the equivalent feet of elbows or transitions to be used should equal 40 feet or less.
The equivalent feet of various roof and wall caps has been taken into consideration. Do not include them in this calculation.
