NATURAL GAS CONNECTION
Side Burner Location
Your grill and side burner have been designed for outdoor use ONLY.
This side burner mounts on the right side of a Broilmas- ter® gas grill and cannot be used with another grill or for any other purpose.
You should never install or operate your grill and side burner in any building, garage, or other enclosed area.
For your safety, the grill and side burner should not be installed or operated under any combustible materi- als, such as carports, covered porches, awnings, or overhangs.
Never install or use your grill and side burner in or on any recreational vehicle or boat.
CAUTION: The installation and operation of this grill and side burner at clearances less than speci- fied below may cause a fire, property damage, or personal injury.
A minimum clearance of sixteen (16") inches is required from all sides of the side burner to any combustible material. Refer to the grill’s Owner’s Manual for specific grill clearances.
Examples of combustible materials are patio furniture, fences, or the wall of your home.
The area surrounding the grill and side burner should be clear to ensure proper ventilation. Do not obstruct the flow of combustion and ventilation air in any way. The ventilation openings on the propane cylinder enclosure must also remain free and clear of debris.
Portable grills with side burners should be level and positioned away from direct wind prior to each use.
WARNING: Do not install or operate this grill and side burner where gasoline or other flammable materials are used or stored. Failure to comply with this warning could result in explosion or fire causing property damage or personal injury.
Gas Type
Your Broilmaster® side burner is factory equipped for LP gas and must be converted for use with Natural gas grills. Never use liquid propane gas with a grill designed for natural gas, or natural gas with a grill designed for liquid propane gas. The type gas required for your grill can be determined from its product identification label. Questions regarding different types of gases should be directed to your gas company.
Caution: Never use liquid propane gas in a grill designed for natural gas, or natural gas in a grill designed for liquid propane gas. Questions regard- ing different types of gases should be directed to your local gas company.
1.Remove burner cap.
2.Remove 2 phillips screws from burner head. Im- portant: Do not discard this screw; it will be rein- stalled.
3.Use a 7 mm nut driver or socket wrench to remove the LP orifice and replace it with the Natural gas orifice supplied.
4.Replace the 2 phillips screw into burner head.
5.Turn set screw in center of valve stem 1/2 turn counterclockwise.
6.Apply soapy solution to test for leaks around the set screw. If a leak is found, turn screw clockwise until bubbles cease.
Important: Place conversion label inside lid adjacent to serial number label.
Page 11 |
