GRILL ASSEMBLY
Ignitor Assembly
Slide the collector box spacer and nut (provided on assembly) onto the collector box shaft and tighten. See Figure 8.
Note: Peel protective film from control panel label before installing ignitor.
Nut
Installing the Ignitor
Caution: Do not cut or damage ignitor wire.
Carefully thread the end of the ignitor wire through the center hole in the grill bottom. Slide the ground lug over the ignitor wire and fasten with nut provided.
Attach one end of the ground wire to the terminal on the rear of the electronic ignitor. Attach the remaining end to the ground lug.
See Figures 8 and 9.
Attach ignitor wire to the spark terminal on the rear of the electronic ignitor.
Figure 8
Figure 9
Installing Control Knobs
Place control knobs onto valve stems. The knobs will only fit onto
the stems one way.
Page 25 |
