CHAPTER 5 MAINTENANCE
5-34
3. Install the new Transfer Roller by
holding the Lock Levers of the
Transfer Roller and adjusting the
angle of the Transfer Roller Lever
shafts (both sides) to match the
Transfer Unit groove. Set the
Transfer Roller onto the shafts and
place the Roller onto the springs as
shown below:
Fig. 5-32
Fig. 5-33
Fig. 5-34
4. Lock the new Transfer Roller into place with the Transfer Roller Lock
Levers.
5. Close the Rear Access Cover.
6. Plug the power cord into the power outlet, and then press the Power
button to turn on the printer.
7.
Press any of the Menu buttons (+, –, Set or Back) to turn the printer Off
line.
8. Press + or – until “RESET MENU” appears.
9. Press Set to proceed to the next menu level, and then press + or – until
��PARTS LIFE” appears.
Transfer Rolle
r
Shaft
Spring
Lock
Levers