Chapter 2
Figure 1 | Figure 3 |
NOTE
The sensor is at this position immediately after the printer is purchased.
Figure 2
1
2
3
4
5
1Back of media
2Black mark
30.16" (4 mm) or more
4Centerline
5Reflective/black mark sensor
NOTE
When using receipt paper with the maximum width of 2.4" (63 mm), make a black mark at least 0.35" (9 mm) long in from either the left or right edge of the paper so that the reflective/black mark sensor can detect the black mark. If the black mark is too short, it cannot be detected by the reflective/black mark sensor.
Cutting Roll Paper
Roll paper can be cut using the printer’s tear bar. Pull one edge of the ejected paper up and diagonally toward the other edge.
CAUTION
The tear bar is sharp. To avoid injury, do not touch the tear bar.
18