BT Digital Baby Monitor Plus – Edition 4 – 26.02.04 – 5740
Setting up | 5 |
|
|
Baby Unit
Once your Parent Unit has been fully charged:
1.Plug the mains power cable into the socket marked 
on the side of the Baby Unit. Connect the other end to the mains power and switch on.
Using batteries
Your Baby Unit also works on battery power, so that you can use it even when you are not near to a mains power socket or during a power cut.
1.Using your finger or a coin, turn the battery lock on the back of the Baby Unit anti-
clockwise so the groove is | Unlock | Lock |
horizontal then lift off the |
|
|
cover. |
|
|
2.Insert 4 x AA Alkaline batteries (not supplied)
as shown.
3.Replace the battery cover, turning the battery lock into the vertical position again to lock it.
Check the connection
When both Units are switched on, the green link lights on both Units will come on.
If the link between the Units is broken at any time, the link lights will turn red and flash slowly and Not Linked will be displayed on both Units.
At the Parent Unit, you will also hear an alert signal (3 beeps) to warn you that there is no communication between the Units. If this happens, check that the mains power is plugged in and switched on at the Baby Unit. Also check that the Units are within range of one another.
!WARNING
Use only the mains power adapter supplied. Using an incorrect adapter may permanently damage the Baby Monitor.
Please note
The Baby Unit will only work from the batteries if the mains power is off or disconnected.
Battery performance
The recommended batteries are 4 x AA Alkaline (2500mAh).
With new batteries, your Baby Unit will give up to 24 hours continuous performance with the night lights switched off. This will be less if the lights are switched on.
When the Baby Unit is not being used and is disconnected from the mains power, you should ensure you remove the batteries. This will prevent the batteries discharging.
In the event of power failure, when the power is restored all your settings will remain unchanged.
