bühler

Allied Front-End Loader

2.Lower attachment level to the ground

while engaging float position. Ensure attachment rests firmly on ground with minimal downward pressure. If required extend bucket cylinders to rotate upright rearward. At this stage the pin should have no pressure. Set tractor park brake and remove loader lock pins. Check hydraulic hoses such that they will not get pinched or stretched during removal.

WARNING Operate hydraulic controls slowly. Loader will disengage from the mounting kit and may shift if not on firm level ground.

3.Retract bucket cylinders to raise upright and disengage from the loader mount cradle. If additional clearance is required, extend lift

cylinders while slowly backing the tractor away from the loader.

4.After the tractor is clear of the loader,

retract all cylinders to protect the shafting. Shut tractor off and set park brake and relieve oil pressure in hoses by moving valve

control. Disconnect hydraulic loader hydraulic hoses at the quick couplers. IMPORTANT: Cap both male and female couplers. Wrap loader hoses over loader arm.

- 20 -

P4110

Page 22
Image 22
Buhler 2895 manual Bühler