Box Scraper
6
ASSEMBLY
1. Bolt the hitch (#2) and hitch braces (#3) to the frame (#1) using hardware
supplied.
2. Use the position or draft mode on the three-point control to make a cut at
constant depth. Use float when you want the scraper to follow the contour of
the ground. The weight of the scraper itself will keep the blade at the desired
depth.
3. Use the scarifier shanks to break up hard or packed surfaces. If it is
necessary to add weight to the blade, use a maximum of 200 lbs.
4. The two blades allow the operator to scrape or level in either direction. The
shanks should be used to break up compacted material ahead of the blade.
OPERATION
THEORY OF OPERATION
1. Raise the Box Scraper off the ground.
2. Securely block up the frame.
3. Remove shank pins.
4. Install, adjust height or remove as desired. Always keep shanks at the same
depth for best results.
5. Install shank pins.