Drag Harrow
SERVICE AND MAINTENANCE SAFETY
Stop engine, set brake, remove ignition key, and wait for all moving parts to stop before servicing, adjusting, repairing, or unplugging.
Support the equipment with blocks or safety stands before working beneath it. Follow good shop practices including:
-keep service area clean and dry
-be sure electrical outlets and tools are properly grounded
-use adequate light for the job
Use only tools, jacks, and hoists of sufficient capacity for the job.
Use heavy leather gloves to handle sharp objects.
STORAGE SAFETY
Store the unit in an area away from human activity.
Do not permit children to play on or around the stored machine. Support the frame on stands and blocks to provide a secure base.
SAFETY SIGNS
The following illustration shows the approximate location and detail of safety signs. Keep all safety signs clean and legible and replace any that are damaged or missing. When original parts are replaced, any safety signs affixed to those parts should be replaced as well. Replacement safety signs are available from your local dealer.
INSTALLATION OF SAFETY SIGNS
To install safety signs, ensure the installation area is clean and dry. Decide on the exact position before you remove the backing paper. Remove the smallest portion of the split backing paper and align over the specified area. Carefully press in place. Slowly peel back the remaining paper and smooth the remaining portion in place. Small air pockets can be pierced with a pin and smoothed out.
5
