Bunn BCM2 Dimensions & Specifications, Model, Product #, Volts, Amps, Shipping, Watts, Capacity

The Mark of Quality in Beverage Equipment Worldwide

Dimensions & Specifications
Model	Product #	Volts	Amps	Tank Heater	Total	Brewing	Cu. Ft.	Shipping
				Watts	Watts	Capacity		Weight
BCM2	23350.0000	120/240V	30	6700	7200	8.0 gal./hr.	42.6	257 lbs. (116.6 kg)
BCM2	23350.0001	120/208V	30	5700	7200	8.0 gal./hr.	42.6	257 lbs. (116.6 kg)
BCM2*	23350.0002	120/240V	30	6700	7200	8.0 gal./hr.	42.6	257 lbs. (116.6 kg)
BCM2*	23350.0003	120/208V	30	5700	6240	8.0 gal./hr.	42.6	257 lbs. (116.6 kg)

*Auto refill on both sides

Electrical: All are 3-wire, single phase, 60Hz.

Plumbing: Brewers are supplied with a BUNN EasyClear® water filter model 120-CP (product no. 30045.0000).The filter and brewer must be connected to a cold water system with operating pressure between 20 and 90 psi (138-621 kPa) from a 1⁄2" (13 mm) or larger water supply line. Install a regulator in the line when pressure is greater than 90 psi (621 kPa) to reduce it to 50 psi (345 kPa).The water inlet fitting is 3⁄8" (10 mm) OD male flare.

Drain:	The brewer has a 1⁄2" (13 mm) hose barb fitting
	which must be connected to an unrestricted drain.
Physical:	This brewer is for use on a sturdy counter at
	least 26" (66 cm) deep, 23" (58 cm) wide, with at
	least 50" (127 cm) above the counter to allow
	adequate space for filling the hoppers.The brewer
	weighs approximately 220 lbs (99 kg) with both
	ground coffee hoppers, water tank, and waste
	bin full.

All dimensions shown in inches.