FACTORY AUTHORIZED SERVICE
| '0551 BLE CAUSE |
NO HOT | 1. Tank heater |
WATER |
|
WHAT TO CHECK
1.Voltage at tank heater terminals with control thermostat knob in the fully clockwise position.
Voltage should be: Model F35
240 volts A.C. Models F20 and F15 120 volts A.C.
REMEDY
1.If correct voltage is
present at the tank heater terminals and
water in tank is not being
heated, replace tank heater.
If voltage is not present at tank heater termina Is, refer to step 2.
If incorrect voltage is present on tank heater terminals, refer to "Electrician's Installation Instructions."
2. Limit Thermostat or Control Thermostat.
STEAMINGControlTankSolenoidTurnWaterExcessive(A)BrewerknobandshouldmustvalvetankLimecounterflowbelid. - from 21. 1lower. Thermostatinfrontto
KnobBeIfNotInsertlimesureSiphoningSettingbuilddelimingspring.upisisinplacesprayheadexcessive,siphonorandproperlyslightlyanylevel fordelimeapproxparticles.tank-
ff.holesthermostatandarebackseat(C) cleaned.air.andIftubevaIve.forthfromallseatfivethevalve
s springwaydecrease,replaceproperlyis(B)inworntankwaterintoCleansolenoidortanklidreplacetubemultilated,sprayheadassemblyand controlsaw..
WATER KEEPS | 1. Solenoid Valve |
RUNNING |
|
(BREWER WON'T |
|
SHUT OFF |
|
ELECTRICALLY) . |
|
2.With control thermostat knob in the fully clockwise position, check the voltage between the
white (or red) wire on the tank heater terminal
and the incoming terminal (black wire) on the limit thermostat, then the outgoing (blue wire) terminal on the
limit thermostat. Voltage should be: Models
F15 and F20, 120 volts
A.C. Model F35, 240 volts A.C.
or six times. clockwise for lower
1.Refer to "Dripping" section, step 2.
2.(A) If voltage is present on incoming terminal (black wire) on the limit thermostat, but not on the outgoing terminal, (blue
wire) replace limit thermostat.
(B)If voltage is present on both terminals on the limit thermostat, but not across tank heater
terminals, replace control thermostat.
(C) If voltage is not
present on the incoming terminal on the limit
thermostat, refer to "No Power" Section.
ofsetting.water Ifdoestemperaturenot
1.Refer to "Dripping" section, step 2.
5
