Bunn B10, GR10-B Preparing The Brewer For Use, Empty any water that has collected in the decanter

PREPARING THE BREWER FOR USE

NOTE - THE BREWER IS NOT READY TO PLUG IN. Do NOT plug in until Step #3.

Step 1

Raise the hinged flip-lid.

NOTE: The post protruding from the screen is con- nected to a stopper which controls the flow of water into the tank. When lid is closed (post depressed), the stopper is raised and water will flow into the tank.

Step 2

Slide an empty brew funnel into the brewer under the warmer switch.Pour one decanter full of water into the screened area on top of the brewer.Place decanter on the warmer. Close lid.Wait three minutes to allow the water to flow into the tank. Repeat this process When the tank is full,some water will flow through the funnel and into the decanter.

Step 3

Plug in the brewer.

P2240

P2247

P-214

Step 4

Press the bottom of the vacation switch, located on the lower left side of the brewer, to the “ON” (lower) posittion.

The vacation switch controls power to the tank heaterr. Initially you will have to wait approximately fifteen minutes in order for the water to reach brew tem- perature.

Empty any water that has collected in the decanter

P-219

The next page leads you through the five easy steps to

‘BREWING DELICIOUS COFFEE’

6