Page 19
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET NEW RECIPE - METHOD 2
Using a RECIPE CARD to load coffee names and brew
settings into the Single Multi-BrewWISE DBC with
Smart Funnel:
The Multi-BrewWISE DBC Grinder's memory con-
tains certain coffee names. If the operator uses a
coffee name that is not already stored in the grinder's
memory, a RECIPE CARD can be obtained from the
factory. The RECIPE CARD would include all the infor-
mation needed to set up that particular coffee name.
The information from the RECIPE CARD is loaded into
the grinder's memory, then into the brewer's memory
by holding the recipe card up to the equipment's
sensing coil. This information can include the coffee
name, BREW VOLUMES, DILUTION PERCENTAGES,
PULSE BREW TIMES, PREINFUSION TIMES and DRIP-
OUT TIMES for that particular recipe NAME. These can
all be loaded in seconds.
Contact Bunn-O-Matic Corporation for the avail-
ability of RECIPE CARDS.
NOTE: Instructions to program the brewer and grinder
are printed on the RECIPE CARD, along with the coffee
name that is being programmed.
Procedure to program the coffee name:
1. Remove the funnel (if present) from the funnel
rails.
2. Position the RECIPE CARD vertically, so that the
top end of the chip is beneath the funnel sensing
coil.
3. After a short pause the display will read CARD
CONTAINS RECIPE FOR then will change to
(RECIPE NAME) SHOW QUIT SAVE. All brewing
parameters for that coffee flavor are now trans-
ferred from the CARD to the brewer.
4. To show (view) this information, press and release
SHOW. The display will scroll through all of the
brew settings for all batch sizes. The display will
then return to CARD CONTAINS RECIPE FOR then
will change to (RECIPE NAME) SHOW QUIT SAVE.
5. If all brew settings are correct, press SAVE. The
display will read (RECIPE NAME) SETUP COM-
PLETE. All brew settings for that name are now
stored in the brewer's memory.
6. If the brewing information is not correct, or it is
desired to exit the setup before the settings are
loaded into the brewer's memory, press QUIT. The
display will read (RECIPE NAME) NOT SAVED. The
display will then return to the MAIN SCREEN.
POSITION CARD UNDER
SENSOR COIL
(RECIPE NAME)
SHOW QUIT SAVE
CARD CONTAINS
RECIPE FOR
READY TO BREW
WATER TEMP: 93º
(RECIPE NAME)
SETUP COMPLETE
(RECIPE NAME)
NOT SAVED
SCROLLS THROUGH ALL
OF THE BREW SETTINGS
FOR THE BATCH SIZES
FOR THAT RECIPE
P3210
37467 110904