Bunn ITCB, ITCB, ITCB-DV READY TO BREW WATER TEMP: 205, CARD CONTAINS RECIPE FOR, SHOW QUIT SAVE, SETUP COMPLETE , NOT SAVED

Page 24
2. Position the RECIPE CARD vertically, so that the
top end of the CHIP is beneath the SENSING COIL
(located on the middle of the underneath side of
the front display panel).
3. After a short pause the display will read CARD CON-
TAINS RECIPE FOR then will change to (COFFEE
NAME) SHOW QUIT SAVE. All brewing parameters
for that coffee fl avor are now transferred from the
CARD to the brewer.
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
BREW
A
BREW
B
BREW
C
5 SEC.
POSITION CARD UNDER
SENSOR COIL
SCROLLS THROUGH
ALL BREW SETTINGS
FOR THAT RECIPE
READY TO BREW
WATER TEMP: 205°
READY TO BREW
WATER TEMP: 205°
CARD CONTAINS
RECIPE FOR
(COFFEE NAME)
SHOW QUIT SAVE
(COFFEE NAME)
SETUP COMPLETE
(COFFEE NAME)
NOT SAVED
P2856
36748 101505
15. The display should now read DRIP TIME, along with
either the word OFF or a time showing. A batch
light will also be blinking.
16. Using (-) and (+), set the amount of time from when
the brew spray ends to when the funnel is emptied
of hot liquid.
17. When fi nished, press the other batch size and repeat
step #16
18. When fi nished setting both batch sizes, press DONE.
The display should read 2 BATCHES DONE?
19. Press and release YES.The screen should show the
name of the coffee being programmed (modifi ed)
along with SETUP COMPLETE.
20. After a 5 second delay, the display will advance to
the next coffee name in the brewer’s memory. If
no other coffee names are present, the display will
read THAT WAS THE LAST RECIPE, and advance
to the MASTER TEMP screen.
SET NEW RECIPE
Using a RECIPE CARD to load coffee names and brew
settings
The G9-2T DBC or MHG Grinder’s memory contains
certain coffee names. If the operator uses a coffee name
that is not already stored in the grinder’s memory, a
RECIPE CARD can be obtained from the factory. The
RECIPE CARD would include all the information needed
to set up that particular coffee name. The information
from the RECIPE CARD is loaded into the grinder’s
memory, then into the brewer’s memory by holding
the chip area up to the equipment’s SENSING COIL.
This information can include the coffee name, BREW
VOLUMES, PULSE BREW TIMES and DRIP OUT TIME
for that particular coffee name. These can all be loaded
in seconds.
Contact Bunn-O-Matic Corporation for the availability
of RECIPE CARDS.
NOTE: Instructions to program the brewer and grinder
are printed on the RECIPE CARD, along with the coffee
name that is being programmed.
Procedure to program the coffee name:
1. Remove the funnel (if present) from the funnel
rails.