Page 30
TIMER (Early Models)
FIG. 27 TIMER
P2114.40
Location:
The timer is located behind the front access panel
on the right side of the component bracket.
Test Procedures:
1. Disconnect the brewer from the power source.
2. Disconnect the polarized, three pin connector from
the brewer main harness and rotate the brew timer
dial fully counterclockwise.
3. With a voltmeter check the voltage across sockets
P2 and P3 (white and black wire or red wire) of the
female connector on the main wiring harness
when the "ON/OFF" switch is in the "ON" (upper)
position. See chart below for P2 and P3 wires: