SERVICE (cont.)
START SWITCHES
P/N 37079.0000 | P/N 37080.0001 |
Non Lighted | Green ready light |
FIG. 16-1 START SWITCHES
Location:
The start switch is located in the front of the hood, above and to the right of the brew funnel.
Test Procedure:
1.Disconnect the brewer from the power source.
2.Remove the wires from all four terminals.
3.Check for continuity across the two terminals on the right side of the switch when it is held in the lower position. Continuity must not be present across these terminals in the upper position.
4.Check for continuity across the two terminals on the left side of the switch when it is held in the lower position. Continuity must not be present
across these terminals in the upper position.
If continuity is not present as described, replace the switch.
If continuity is present as described, reconnect the wires, the switch is operating properly.
If continuity is not present as described, replace the switch.
NOTE: No continuity will show across the left terminals of the lighted switch since the light is neon.
Removal and Replacement:
1.Remove the wires from the switch terminals.
2.Compress the clips inside the hood and gently push the switch through the opening.
3.Push the new switch into the opening and spread the clips to hold the switch captive in the hood.
4.Refer to Fig. 16-2 when reconnecting the wires.
Page 16
WHI/YEL
to Timer T5
WHI/ORN
to Timer T3
P/N 37079.0000
WHI/YEL
to Timer T5
GREEN
WHI/ORN
to Timer T3
RED
P/N 37079.0000
WHI/YEL
to Timer T5
BLK
to T. Stat
WHI/ORN
to Timer T3
BLU/BLK
P/N 37080.0001to T. Stat
FIG. 16-2 START SWITCH TERMINALS
41722 070209
