SERVICE

This section provides procedures for testing and replacing various major components used in this brewer should service become necessary. Refer to Troubleshooting for assistance in determining the cause of any problem.

WARNING - Inspection, testing, and repair of electrical equipment should be performed only by qualified service personnel. The brewer should be disconnected from the power source when servicing, except when electrical tests are required and the test procedure specifically states to plug-in the brewer.

COMPONENT ACCESS

WARNING - Disconnect the brewer from the power source before the removal of any panel or the replacement of any component.

All components are accessible by the removal of the top cover and fill basin.

The top cover is attached with two #4-40 screws.

P2412-1

FIG. 1 COMPONENT ACCESS

The tank inlet fitting secures the fill basin to the tank lid.

 

P2413

FIG. 2 FILL BASIN REMOVAL

 

Contents

 

Control Thermostat ................................................

9

Limit Thermostat..................................................

10

Tank Heater .........................................................

10

Wiring Diagrams .................................................

12

CONTROL THERMOSTAT

P2414

FIG. 3 CONTROL THERMOSTAT

Page 8

39064 042806