![](/images/new-backgrounds/1105668/10566837x1.webp)
MOTION CONTROL LEVER ADJUSTMENT
1.There are three lever height positions available. Place the levers in the position that provides the most confortable operating position for you.
2.Align the levers front/rear position. With the levers in the neutral position, loosen the hard- ware and adjust the levers by tilting forward or backward until properly aligned. tighten hardware.
Lever Position Adjustment Bolts
MOTION CONTROL STEERING ADJUSTMENT
1.Raise the drive wheels of the Zero Turn off of the ground. Safely block the frame in this position so it is secure. This adjustment must be made with the drive wheels turning.
2.Remove the electrical connection from the seat switch and temporarily install a jumper wire across the terminals of the wiring harness.
3.Loosen the jamnuts on the hex turnbuckle, which connects the lever control arm to the pump control arm. Note: The nuts to the front of the hex turnbuckle have left- handed threads.
4.Start the engine. Run the engine at full throttle and release brake.
5.Position the control levers in the neutral position. If the drive wheels creep (rotate) in the neutral position then lengthen or shorten the turnbuckle assembly. Make the adjustment to stop the wheel from rotating.
6.
7.Shut the unit off. Remove the jumper wire from the wiring harness and replace the connectors into the seat switch. Never operate the mower unless all safety switches are operating properly.
DRIVE ADJUSTMENTS
Steering and motion controls should be uniform in all forward and reverse speeds. From the reverse, or forward position, the levers should automatically return to neutral when released.
CAUTION
STOP THE ENGINE BEFORE MAKING ADJUSTMENTS.
TEST DRIVE OPERATIONS
Check air pressure in tires. Equal tire pressure is critical for proper drive operation.
1.Raise drive wheels off ground. Safely block the frame in this position.
2. Put control levers in neutral lock position (control levers swung outward).
3.Start engine. Wheels should not rotate. If one or both drive wheels are turning, perform proce- dures under “Motion Control Adjustment” for side(s) that wheel turns.
Control Arm
Hex Turnbuckle
Jamnut
Control Arm Lever
Pump
Control Arm
17