SETUP AND OPERATION
WARNING: Insure the weapon is unloaded and the safety selector is in the ”safe” position before attempting to install, remove or perform maintenance on the sight.
Installing the Battery
a)Remove Battery Cap by turning it counter clockwise.
b)Insert a battery (type CR2032) with positive (+) end toward Cap.
c)Install Battery Cap by turning clockwise until snug. Hand tighten only, using a coin or similar item. Using tools could damage the equipment. Note: (not necessary when the sight is new) Before installing the Battery Cap (2), inspect that the
d)Verify that red dot is present by turning the Rotary Switch clockwise.
Installing the Sight on the Firearm
The Micro Sight is designed for installation on most types of weapons, which have a
Installing the Sight on a Picatinny/Weaver Rail
a)Loosen the Shaft by means of the Allen Wrench, so that the Locking Bar (12) can clamp around the Picatinny/ Weaver Rail.
b)Install the Sight to the weapon Rail by tightening the Shaft). First, ensure that the Sight is correctly positioned and that the Shaft (=recoil stop) fits into a groove on the Picatinny/Weaver Rail.
To make sure that the Shaft is firmly tightened, screw the Shaft clockwise until a light resistance can be encountered.
After that, screw another 1/4 to 1/2 turn. WARNING! Do not overtighten.
c)When using Lens Covers, ensure that they are correctly positioned and can easily be opened.
d)Finally, make sure that the Shaft with Locking Bar is firmly tightened around the weapon Rail.
e)Complete zeroing according to the "Zeroing" section below.
Lens Covers
In order to preclude the loss of the lens covers when removed from the optical path of the Sight, the lens covers should be removed downwards. The rubber string will then grab around the Sight and Base.
4
