Instructions for Setting Up and Using the wireless
This package is designed to enable the user to wirelessly send and receive audio signal from an A/V processor to the ButtKicker Power Amplifier.
Before beginning, please make sure you have the following:
•
•
•Two 1.5m long RCA cables, male to male - included with the
•ButtKicker Power Amplifier,
•ButtKicker(s) that are already appropriately installed. Sold separately.
•A/V processor, sold separately
“R7H-BKLINK-R” Receive Unit setup:
•Plug one end of the RCA audio cable supplied with the
•Plug the a/c adapter into a wall outlet. Plug the jack end into the back of the Receive unit.
“R7H-BKLINK-S” Send Unit (transmitter) setup:
•Using a RCA audio cable, plug the subwoofer output from the A/V processor into the RCA jack in the back of the
A RCA “Y” connector or Guitammer’s “Speaker Interface Level Adaptor” may be used to enable the use of both a subwoofer and the ButtKicker with the A/V processor or to connect to A/V processors that do not have a RCA subwoofer output.
Note: RCA “Y” connector and Speaker Level Interface Adaptor cable are part of the
•Plug the a/c adapter into a wall outlet. Plug the jack end into the back of the Send unit.
•With normal playback volumes set on your home theater system, adjust the potentiometer on the back of the Send unit to where the red light just starts to blink. This sets the RF gain below clipping. Should another source interfere with the
•Turn on the ButtKicker Power Amplifier and adjust the volume control (and high and low cutoff’s if wanted) to your desired level.