Cabletron Systems 12 The Reset Switch

2-7

Installing the 9E428 and 9E429 Modules

The Reset Switch

The Reset switch is located on the front panel, under the top plastic tab as shown

in Figure 2-4. It serves three functions: resetting the i960 processor, shutting down

the module, or restarting the module.

• To reset the i960 processor, press the reset switch twice within three seconds.

• To shut down the module, press and hold the reset switch down for three or

more seconds.

• To restart the module after it has been shut down, press and release the Reset

Switch.

For security, SNMP management can be used to disable the functions of this

switch.

Figure 2-4. The Reset Switch

Reset Switch

Contents

Main Page i Notice Notice ii Notice FCC Notice VCCI Notice Page DECLARATION OF CONFORMITY ADDENDUM Contents Chapter 5 Specications Chapter 1 Introduction Features Page Introduction 1-4 SMB CPU The 9E428-12/36 and 9E429-12/36 Modules 10 BASE-T FNB 10 BASE-T Related Manuals Getting Help Page Chapter 2 Installing the 9E428 and 9E429 Modules Unpacking the Module User Accessible Components St Page Installing the 9E428 and 9E429 Modules 2-4 See the ! Page Page The Reset Switch Page Chapter 3 Operation Operation 3-2 Figure 3-1. Packet Flow for the 9E428-36 and 9E429-36 ENIB 1 2 SMB 1 SMB 10 SmartSwitch ASIC i960 Core INB NIB System Management Buses SMB-1 Bus SMB-10 Bus System Diagnostic Controller DC/DC Converter INB Interface ITDM Arbitration levels Monarch/Slave SmartSwitch 9000 Modules Chapter 4 LANVIEW LEDs LANVIEW LEDs 4-2 The functions of the INB Receive LEDs are listed in Table 4-2. The functions of the INB Transmit LEDs are listed in Table 4-3. The functions of the Port Transmit LEDs are listed in Table 4-5. Page Chapter 5 Specications Technical Specications Safety Service Physical !