Cabletron Systems 802.11 manual Verify Component Connector Polarity

Site Preparation Guide

Verify Component Connector Polarity

The components supplied with your Outdoor Antenna Kit are configured with either Standard-N connectors or Reverse Polarity-N connectors, subject to the country where the kit was purchased. Refer to the following table to verify that the polarity of each connector is correct for your installation.

1

2

Pigtail

Lightning

Low-Loss

Antenna

Connection

Protector

Cable

Cable

(A)

(B)

(C)

(D)

ETSI Countries, France, Spain, and

FCC Countries

Japan

Standard-N Male

Reverse Polarity-N Female

Standard-N Female

Reverse Polarity-N Male

A

1 - PC Card connector

1 - PC Card connector

2 - Standard-N Male

2 - Reverse Polarity-N Female

B

Standard-N Female on both ends

Reverse Polarity-N Male on both ends

C

Standard-N Male on both ends

Reverse Polarity-N Female on both ends

D

Standard-N Female

Reverse Polarity-N Male

NOTE

The term Male or Female does not refer to the connector thread, but to its center pin.

•Male connectors have a solid center pin.

•Female connectors have a hollow center pin

If you wish to purchase individual components, make sure you specify the correct N-Type connectors to match the configuration that applies to your country.

15