Cabletron Systems 9W111-08 manual Installing the MMAC-Plus Module, 4. Console Cable Pinouts

Installing the MMAC-Plus Module

An RJ-45 connector provides a COM interface to the management terminal. Figure 2-4shows the pinouts.

Pin 1

RJ-45 COM PORT

RJ-45 TO 25 PIN	FEMALE - 25 Pin
CABLE	"D" Shell Connector

RECEIVE	4
TRANSMIT	1
SIGNAL GROUND	5
DATA SET READY	2
DATA TERMINAL READY	6

2 TRANSMIT

3 RECEIVE

7 SIGNAL GROUND

20 DATA TERMINAL READY

5 CLEAR TO SEND

COM PORT			LOCAL
RJ-45			MANAGEMENT
			CONSOLE
			RECEIVE
TRANSMIT	1	2
RECEIVE	4	3	TRANSMIT
SIGNAL GROUND	5	5	SIGNAL GROUND
DATA SET READY	2	7	READY TO SEND
DATA TERMINAL READY	6	8	CLEAR TO SEND

RJ-45 TO 9 PIN	FEMALE - DB-9
	(9-Pin Connector)
CABLE

Figure 2-4. Console Cable Pinouts

Connect the console to the module as follows:

1.Attach the male RJ-45 connector to the COM port of the 9W111-08.

2.Attach the female end (25-pin or 9-pin, as applicable) to the terminal.

Refer to the Cisco Systems documentation for the R4500 router, for information on configuring this module.

2-6