ZRS C1
1-Ohm Mono Load
Woofer Wiring
Remote turn on
from radio, do not
wire woofers to
this terminal!
DVC
Wired in Parallel
to | DVC |
Wired in Parallel
to
=
DAISY CHAINING AMPLIFIERS - HOW TO SET SWITCHES, INPUTS AND REMOTE CONTROL.
When daisy chaining two amplifiers together all pre amp signals including crossover, phase control, bass equalizer, input gain, subsonic filter, bass focus are controlled by the Master amplifier. The entire pre amp section of the Slave amplifier is bypassed. This is done so all you have to do is to set the Master amplifier and the Slave amplifier will match the Master exactly. There is no need for any manual matching to occur. This ensures perfect alignment of your system. One Bass Control knob, plugged in to the Master amplifier will also control both amplifiers, thereby simplifying your installation as well.
Use the RCA Pre amp Output of the Master Amplifier to feed secondary Full Range | Daisy Chaining | |
Set Master Amplifier to “MASTER” | ||
Set Salve amplifier to “SLAVE 1” | ZRS C1 Amplifiers | |
Set Phase Shift on both amps to same position. | ||
| ||
Set all crossover setting, bass equalizer, subsonic filter, bass focus on MASTER amp to desired settings. |
| |
| ||
|
Use the “Bridging Cable” which was supplied with amplifier to connect MASTER OUT of amplifier #1 (Master) to SLAVE IN of amplifiers #2 (SLAVE). Do not substitute any other cable, if you need a longer cable or lost your cable, please contact Cadence.
Connect woofers as you would typically connect them to each amplifier, not exceeding a 1 ohm load per amplifier. You can daisy chain as many ZRS C1 as you like while retaining control of your entire system from the Master amplifier.
RCA Headunit signal to Master Amp only! No RCA Cables to be attached to Slave Amplifier.
Amp #1 in Master Mode
Amp #2 in Slave 1 Mode
Fully adjusted Signal
is transferred from Master to Slave Amp via Phone Cable.
Final Impedance
Load!
When daisy chaining two ZRS C1 amplifiers, you can wire each woofer to any of the amplifiers positive or negative terminals as they are wired internally in parallel.
Under no circumstances can you daisy chain two
different models of amplifiers.
Final Impedance
Load!