Califone 1886 CD Operation, Recording from the CD Player to Cassette Deck, Handling Compact Discs

5.To activate recording, release the PAUSE button.

6.To stop recording temporarily, press the PAUSE button. To continue the recording, press the PAUSE button once again.

7.Press the STOP/EJECT button to stop recording.

8.When the tape runs to its end, the cassette operation will be stopped automatically.

RECORDING FROM THE BUILT-IN CONDENSER MICROPHONE TO CASSETTE DECK

1.Set the FUNCTION SELECTOR SWITCH to the TAPE position.

2.Open the CASSETTE COMPARTMENT by pressing the STOP/ EJECT button and insert a blank tape into the CASSETTE COMPARTMENT. Close the door gently.

3.Press the RECORD button and PLAY button simultaneously to start the recording process. This process will record the signals that are received by the built-in CONDENSER MICROPHONE.

4.Press the STOP/EJECT button when finished.

NOTE: Monitoring during MICROPHONE recording is not possible.

RECORDING FROM THE CD PLAYER TO CASSETTE DECK

1.Slide the FUNCTION SELECTOR SWITCH to "CD" position.

2.Put a CD into the CD COMPARTMENT with the label side upward.

3.Insert a blank cassette into the CASSETTE COMPARTMENT and press PAUSE button of the cassette deck.

4.Press RECORD button and PLAY button simultaneously for recording stand-by. With the built-in ALC, the best recording quality is adjusted automatically.

5.Activate the CD players, playing in a desired TRACK as described in the COMPACT DISC PLATER OPERATION section. Release the PAUSE button of the cassette deck to start recording.

6.To stop recording temporarily, press the PAUSE button. To continue recording, press the PAUSE button again.

7.Press STOP/EJECT button of the cassette deck to stop recording. Then stop CD playback by pressing the STOP button of the CD player.

califone.com

5.3 CD OPERATION

HANDLING COMPACT DISCS

This unit is designed to play only compact discs bearing the identification logo below.

Other discs may not conform to the CD standard and may not play properly.

•Dirty, scratched or warped discs

may cause skipping or noise.	INSERT WITH	PRESS THE CLAWS
	THE LABEL
		ATTHE CENTER OF
• Handle the disc only by the edges. To	FACING UP.	THE DISC CASE.
keep clean, do not touch its surface.
• Discs should be stored in their	PRESS THE	LIFT OUT WITHOUT
	DISC GENTLY	TOUCHING THE
cases after use to avoid serious scratches.	TO INSERT IT.	RECORDED SURFACE.
• Do not expose disc to direct
sunlight, high humidity, high		INCORRECT
temperature, dust, etc.
Prolonged exposure to extreme
temperatures can warp the disc.	CORRECT	INCORRECT
• Do not stick or write anything on either
side of disc. Sharp writing instruments or	FROM THE CENTER TO THE EDGE
the inks used in some felt tip pens may
damage its surface
Remove the disc

•To pick up the disc, hold the edge and

gently press the center pivot

as illustrated. CAUTION: Wait for the disc to stop rotating before

pressing the OPEN button.

NOTE: This unit can play 3” (8 cm) single CDs

without an adapter. Do not use a CD single adapter for these discs.

CLEANING DISCS

Finger prints should be carefully wiped from the surface of disc with a soft cloth. Unlike conventional records, compact discs

have no grooves to collect dust and microscopic debris, so gently wiping them with a soft cloth should remove most particles. Wipe in a straight motion from the center to the edge. Never use thinner, benzine, record cleaner or anti-static spray on a compact disc. Such chemicals can damage its plastic surface.

NOTE: Should skipping of tracks occur during CD playback, try turning the volume down. When CD is playing, do not open the CD Door.

califone.com

10 11