While holding the assembly in place on the back side of the tile, place the speaker assembly through the hole and attach to the Circular Speaker Bracket using the four screws on the outer edge of the speaker. Be careful not to tighten the screws too far to avoid damaging the tile. Do not attempt to bend or reshape the Circular Speaker Bracket, as doing so may cause the speaker to fall.
Replace the tile, making certain to position the Bridge Brackets ends so that the frame is supporting them at all four points.
Installing in a Sheetrock (Plasterboard) Wall or Ceiling
Please note that the speaker can be installed in walls or ceilings with a maximum thickness of 1.25 inches. In buildings with older
After you've chosen your ideal speaker locations, use a stud finder to locate the studs in that area of the wall or ceiling. Inspect the selected area for AC circuitry, water pipes and other infrastructure. When drilling into walls or ceilings, use caution to avoid damaging these items.
To make sure the area behind your wall is clear, drill a hole in the center of the template.
Bend a wire coat hanger to 90 degrees, so that the end of it meets the edge of the circle you’ve drawn.
Insert the wire into the hole and rotate it 360 degrees to make explore the area for obstructions.
If it’s clear, you can then use a drywall saw to cut the speaker hole. (Hint: drill a hole along the circumference of the circle to create a starting point for your saw.)
Do not cut any drywall until you've drilled pilot holes and checked all of your desired speaker locations. If one location doesn’t work, you might need to move others as well.
Do not discard the cut away piece of drywall until you’ve completed the job, in case you need to use some for patching.
Position the speaker into the hole and tighten the four screws on the outer edge to secure it to the wall or ceiling. Be careful not to tighten the screws too far to avoid damaging the wall or ceiling.
Unpacking the Unit
Inspect the unit once the packaging has been opened for any damage occurred during shipping & contact us immediately. Please keep the packing
material for further use.
Contents
The CS308 kit contains the
CS308-SPK Contents:
•Speaker with integrated UL
•Speaker grille removal tool
•Black adhesive for attaching speaker grille
•Cardboard template / paint mask
CS308-MNT Contents:
•Circular Speaker Bracket
•(2) Tile Bridge Brackets
•(4) screws for attaching Speaker Bracket to Tile Bridge Brackets
•(4) nuts for screws
Speaker with Cover Assembly | Speaker Grille Removal Tool |
Tile Bridge Bracket | Circular Speaker Bracket |
