Cambridge Audio manual MOUNTING THE SS10, CONNECTING THE SS10

MOUNTING THE SS10

Before mounting, ensure that the four fixing screws are slackened off so that the red mounting dog-legs can move freely.

Move each red dog-leg foot to the LEFT into it’s holding slot, and then insert the speaker into the mounting hole.

Using a cross-head screwdriver, slowly turn each fixing screw clockwise. This will move the mounting dog-legs out of their slots.

Tighten each fixing screw until the mounting dog-legs grip the ceiling.

CONNECTING THE SS10

Do not compromise the performance of your system by using inferior quality speaker cables. We recommend that high quality cables of 16 gauge or higher be used. Your professional dealer will give you good advice. Always unplug all A.C. powered components before making any loudspeaker or component connections. This will avoid the risk of electric shock or damage to your equipment.

Follow these steps to connect the speaker to your amplification system:

1.Route the speaker cable from your amplification system to the speakers.

￿Avoid routing the speaker cable near electrical wires

￿Do not nail or staple the cable

6Incognito passive ceiling speakers

2.Separate about 100mm of speaker cable at each end.

3.Using a wire stripper, remove about 10mm of insulation from both ends of each conductor, and then twist the strands of each conductor (fig.1).

4.Observing polarity is of the utmost importance while connecting your speakers. Ensure that the red (+) terminals on your amplification system are connected to the red (+) on the speakers, and black (-) on your amplification system to black (-) on your speakers (fig.2).

The speaker cable is coded with a bead or stripe down one lead’s insulation, or has differently coloured wires.

Press the spring-loaded red or black tab back to reveal the connecting hole. Insert the stripped end of the speaker wire, then release the tab.

5.If your speakers are wired incorrectly they will be out of phase and sound hollow and indistinct, with a weak bass. Re-check your connections for correct polarity and reverse the connections if necessary.

100mm

10mm

fig.1.fig.2.