Attaching The Desktop Stands
Attaching The Floor Stands
For most applications, the satellite speakers should be used with their desktop stands. Install each stand by inserting it into the “T” shaped socket in the back of each satellite. Make sure to feed the wires through the
For desktop placement, apply the five self adhesive feet to the base of the desktop stands. If you wish to install the rear satellites in the floor stands, do not apply the self adhesive feet to the base of their desktop stands (see diagram D).
The rear satellites (with their desktop stands attached) may be installed in their floor stands.
1. One leg of each floor stand |
has a full length slot, with |
short notches opposite the |
slot at each end. Insert a |
satellite cable inside one of |
these legs by feeding it down |
the length of the full length |
3. | Insert the two solid legs into |
| the outside sockets in the |
| apex joint. |
4. | Slide the back of the satellite’s |
| desktop stand into the front of |
| the slot in the apex joint. The |
| slot’s front is the side further |
| away from the rear leg socket. |
| Make sure the stand is |
| securely pressed into the slot |
C
D
slot. At each end, feed the |
cable through the short |
notches (see Diagram E). |
2. Ensure there are no feet |
attached to the satellite’s |
desktop stand. Insert the |
satellite end of the leg/cable |
assembly into the middle |
socket of the apex joint. Make |
sure the satellite cable exits |
through the short notch and |
not the full length slot (see |
Diagram F). |
(see Diagram F). |
5. At the base of the rear leg, |
gently pull on the satellite |
cable to remove any unneces- |
sary slack in the cable. |
6. Insert a rubber plug into the |
base of each leg, taking care |
to feed the cable out the short |
notch in the rear leg (see |
Diagram G). |
E
6
