Using the Wired Remote

Turningo turn thesystemOn/Off

❒Ensure that the subwoofer’s main power switch is On.

❒Press the Standby/Power Button once. The red indicator above the button shuts off. The

Master Volume Mode Indicator lights up.

❒To switch the system to Standby Mode, press the Standby/ Power Button again.

Notes

•On first power-on, the system uses a preset default master volume level: two volume Level Indicators will be lit.

•On subsequent power-on, the system reinstates the last-used master volume level.

•All volume and Sub/Treble set- tings will be lost if you turn off the main power switch, or remove the AC power cord or wired re- mote, or if there is a power inter- ruption. The system will revert to default master volume and Sub/ Treble levels.

Varying/muting the volume

❒If the Master Volume Mode

Indicator is lit, press or to vary the system volume.

❒If the Master Volume Mode Indicator is not lit, press the Mode Select Button until the

Master Volume Mode Indicator

is lit. Then press or .

❒To increase the rate of adjustment, hold down or .

Notes

•The remote will revert to Master Volume Mode if left idle for some time.

•To mute the master volume, press the Mute Button once. The system volume will be muted. All previously-lit Level Indicators will blink during the muting.

•To return to listening, press the

Mute Button again. Or press

or to return to normal listening.

•For your own safety, reduce the master volume level before switch- ing the system to Standby Mode.

Adjusting Sub/Treble levels

❒Press the Mode Select Button until the Sub or Treble Mode Indicator is lit.

❒To increase or reduce the Sub/ Treble level, press or .

❒To increase the rate of adjust- ment, hold down or .

Notes

•On first power-on, default Sub/ Treble levels (flat response) are applied. Three Level Indicators will be lit to reflect this. Pressing

boosts the level, and causes more Level Indicators to be lit.

Pressing reduces the level, and causes fewer Level Indicators to

be lit.

•Subsequent Sub/Treble settings will be stored during Standby Mode, and recalled when you next turn the system on using the remote.

Using Headphones

❒For private listening, you can connect headphones to the Headphones Output of the wired remote. This will mute all speakers.

❒Adjust the headphones volume as you would for the speakers.

❒The Sub Mode can be used to adjust the bass level you hear from the headphones.

Notes

•Treble settings can be adjusted in the same way as for the speakers.

•When you disconnect the headphones, the system will revert to a preset default master volume setting (two Level Indicators lit), in order to prevent high headphones volume levels from being applied to the system speakers.

Fig 1: Wired

remote

7