Operating Instructions and Assembly Instructions

Airless Paint Sprayers

Skin Injection Hazard:

High pressure spray can inject toxins into blood stream. If injection occurs, seek emergency medical treatment.

Use a face mask/respirator and protective clothing when spraying. Always

spray in a well ventilated area to prevent health and fire hazards. Refer to Material Safety Data Sheets (MSDS) of spray material for details.

Never try to stop leaks with any part of your body.

This system is capable of producing 3000 psi (20 500 kPa). Use only Campbell Hausfeld replacement parts rated at 3000 psi (20 500 kPa) or higher.

To reduce the risk of skin injection:

● Do not aim the

gun at, or spray,

any person or

animal.

● Keep hands and other body parts

away from the discharge. For

removing the nozzle tip, follow the manufacturer’s instructions for turning off the unit and relieving the pressure.

Do not leave the unit energized or under pressure while unattended. When not in use turn off the unit and relieve the pressure in accordance with the manufacturer’s instructions.

High pressure spray is able to inject toxins into the body and cause serious bodily injury. In the event that injection occurs, seek medical attention immediately.

Check parts for signs of damage. Replace any damaged parts.

This spray gun is rated for 3000 psi (20 500 kPa). Do not use on systems designed to produce more than 3000 psi (20 500 kPa).

Always engage the trigger lock when not spraying. Verify the trigger lock is functioning properly.

To lock (engage): rotate tabs on lock to horizontal position.

To unlock (disengage) to spray: rotate tabs on lock to vertical position.

NOTE: If gun sprays while in the locked position follow instructions in Spray Gun Maintenance section for trigger lock.

Verify that all connections are secure before operating. Do not use pliers to tighten or loosen high pressure connections.

Know how to stop your unit and bleed pressure quickly. Be thoroughly familiar with the controls.

Motor is equipped with an automatic thermal overload. Motor will restart without warning, after cooling.

Never aim or spray at yourself

or anyone else or serious injury could occur.

example, do not try to stop leaks

with any part of the body.

● Do not clean spray tip while it is

attached to the spray gun. Remove

spray tip from gun to clean tip

guard.

● Always use the nozzle tip guard. Do

not spray without nozzle tip guard

in place.

● Do not remove tip while cleaning

the pump.

● Only use a nozzle tip specified by

the manufacturer.

● Use caution when cleaning and

changing nozzle tips. Before

LOCKED

TO UNLOCK

UNLOCKED

TO LOCK

 

 

 

 

 

 

 

 

 

 

 

 

www.chpower.com

4