Operating Instructions and Assembly Instructions

Airless Paint Sprayers

Assembly Instructions

Tools required:

u3/4 in. or Adjustable Wrench

u5/8 in. or Adjustable Wrench

Assembly

1.Open packaging and check contents.

2.Remove the equipment and all parts from the carton.

3.If sprayer is on stand, no further frame assembly is necessary.

If sprayer is on a cart, install handle in position shown on cover and tighten knobs.

4.Attach high pressure hose to pump and spray gun using a 3/4 inch wrench (See Figure Below). Do not attach suction assembly at this time.

FIgure - Attach hose

Pump Assembly

Hose

Prime/Spray

Adapter

Valve

Outlet

 

Valve

Housing

Inlet

 

Valve

 

Suction

 

Assembly

Pressure

 

 

Valve

Outlet

 

Prime

 

Button

 

 

Motor

By-pass

 

Hose

 

Suction

Bell

Assembly

Preparation

Airless painting systems, unlike most other power tools, require additional care to ensure proper working order. Following these instructions will significantly increase the likelihood of having a positive paint experience.

It is important that the painting equipment is flush/tested EACH time a new job is started. Each pump is tested at the factory with a fluid that must be flushed from the

system prior to painting. It is also required prior to each successive use to flush the storage lubricant from the system. Use the solvent which will be used to clean the equipment. Refer to the paint manufacturer’s recommendations for cleaning fluids.

www.chpower.com

6