Campbell Hausfeld IN717702AV 6

Operating Instructions

SB504000

Operating Instructions (Continued)

ADJUSTING THE DIRECTION OF THE EXHAUST

	The tool is equipped
	with an adjustable
	direction exhaust
	deflector. This is
	intended to allow	Rotate
	the user to change	Rotate
	the user to change

the direction of the exhaust. Simply twist the deflector to any direction desired.

User - Maintenance

Instructions

CLEARING A JAM FROM THE TOOL

1. Disconnect the air supply from the tool.

2. Remove all nails from the magazine (see Loading/ Unloading). Failure to do so will

cause the nails to

eject from the front of the tool.

3.Loosen cap screws on nose of tool. Slide nose downward and remove from tool to expose jammed fastener.

4.Reinstall nose assembly in reverse order in Step #3.

5.Make sure the trigger and Work Contact Element (WCE) move freely up and down without sticking or binding.

TECHNICAL SERVICE

Please call our Tool Hotline at 1-800- 543-6400 with any questions regarding the operation or repair of this tool or for additional copies of this manual.

FASTENER AND REPLACEMENT PARTS

Use only genuine Campbell Hausfeld

18 gauge fasteners (or equivalent - see Fastener Interchange Information). Tool performance, safety and durability could be reduced if improper fasteners are used. When ordering replacement parts or fasteners, specify by part number.

TOOL REPAIR

Only qualified personnel should repair the tool and they should use genuine Campbell Hausfeld replacement parts and accessories, or parts and accessories which perform equivalently.

ASSEMBLY PROCEDURE FOR SEALS

When repairing a tool, the internal parts must be cleaned and lubricated. Parker O-lube or equivalent must be used on all o-rings. Each o-ring must be coated with O-lube before assembling. A small amount of oil must be used on all moving surfaces and pivots. After reassembling, a few drops of 30W non-detergent oil or equivalent, must be added through the air line before testing.

STORAGE

The tool should be stored in a cool dry place.