Operating Instructions and Parts Manual

CHN70200

 

 

Glossary

Become familiar with these terms before operating the unit.

ActuatE (Tool) — To cause movement to the tool’s component(s) intended to drive the fastener.

ACTUATION SYSTEM —­The use of a trigger, work contact element (WCE) and/ or other operating control, separately or in combination or sequence, to actuate the tool.

Air Inlet ­— The opening in which the compressed air supply is connected, usually by means of a threaded fitting.

Fasteners ­— This nailer uses 18g Brad Nails ranging in size from 5/8 inch to 2 inch.

Magazine — The part of the nailer that holds the Fasteners.

Maximum Air pressure — The maximum allowable pressure of compressed air, as specified by the manufacture, for operating the tool.

No-mar tip — The no-mar tip is designed to eliminate marks caused by the serrated Work Contact Element (WCE) (see Figure 5). The no-mar tip may be removed and tethered to the tool if not required (See REMOVING NO-MAR TIP) or when a slightly deeper countersink is preferred. Simply slide the no-mar off the WCE and attach to the storage post on the tool’s electronic shroud.

psi (Pounds per Square Inch) —Measurement of the pressure exerted by the force of the air. The actual psi output is measured by a pressure gauge on the compressor.

Quick coupler —­A quick coupler is designed to work in combination with a quick plug to quickly and easily join a pneumatic tool to an air hose (see Figure 3).

Quick Plug — A quick plug is designed to work in combination with a quick coupler to quickly and easily join a pneumatic tool to an air hose (see Figure 4).

Regulator ­— A device used to control air pressure to an air operated tool

Thread lock Glue — A locking glue that is applied to the screw threads before installing. Prevents the screws from working loose during tool operation.

Figure 3 - Quick Coupler

Figure 4 - Quick Plug

Figure 5

8www.chpower.com