Operating Instructions and Assembly Instructions
Airless Paint Sprayers
Safety Guidelines
Important Safety Instructions Save These Instructions
This manual contains information that is very important to know and understand. This information is provided for SAFETY and to
PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe the following symbols.
Danger indicates an imminently
hazardous situation which, if not avoided, will result in death or serious injury.
warning indicates a potentially
hazardous situation which, if not avoided, could result in death or serious injury.
caution indicates a potentially
hazardous situation which, if not avoided, MAY result in minor or moderate injury.
Notice indicates important
information, that if not followed, may cause damage to equipment.
Unpacking
After unpacking the unit, inspect carefully for any damage that may have occurred during transit. Make sure to tighten fittings, bolts, etc., before putting unit into service.
Do not operate unit if damaged
during shipping, handling or use. Damage may result in bursting and cause injury or property damage.
General Safety Information
California proposition 65
This product or its power cord may
contain chemicals, including lead, known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
General Safety |
|
| |
1. SAVE THESE |
|
|
|
|
|
| |
INSTRUCTIONS - To |
|
|
|
reduce the risks of fire |
| MANUAL |
|
or explosion, electrical |
|
|
|
|
| ||
shock, and injury to |
|
|
|
persons, read and understand |
| ||
all instructions included in this |
|
manual. Be thoroughly familiar with the controls and the proper use of the equipment.
2. Always wear a mask
or respirator and
eye protection when painting. Be certain
mask or respirator
will provide necessary protection against inhalation of harmful vapors.
3.Keep visitors away and NEVER allow children or pets in the work area.
4.Do not smoke or eat when spraying paint, insecticides, or other flammable substances.
5.Always work in a clean environment. To avoid injury and damage to the workpiece, do not aim the spray gun at any dust or debris.
6.When spraying and cleaning, always follow the instructions and safety precautions provided by the material manufacturer (Refer to MSDS).
Electrical Shock Hazard:
●Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and in the United States, the Occupational Safety and Health Act (OSHA).
●This product requires a grounded 120V, 15 Amp circuit (See Figure 1).
Grounding
Pin
Figure 1 - Grounding
●If the power receptacles available will not fit this equipment’s power cord, then have an appropriate power receptacle installed by a certified electrician.
●Only qualified electricians or service personnel should perform maintenance on the electrical components of this equipment.
●Do not modify any of the electrical components of this equipment.
●Do not use a power cord adapter with this equipment.
●If using an extension cord, use only grounded three wire extension cords that are in good condition.
●Check with a qualified electrician or service person if the grounding instructions are not completely understood or you are in doubt as to whether the equipment is properly grounded.
Appropriate Extension Cord
Gauge for given lengths
Length of Cord | Gauge |
|
|
25’ | 14 |
|
|
12 | |
|
|
10 | |
|
|
www.chpower.com
3