Operating Instructions and Assembly Instructions
Airless Paint Sprayers
Before servicing or resting:
1.Turn the Prime/Spray Control to the Prime position.
2.Turn the pressure control to Low Pressure/Hydraulic Bleeding position.
3.Turn power switch to OFF position.
4.With gun pointed in a safe direction, pull the gun trigger, with the trigger lock disengaged.
5.Engage trigger lock.
●Simply turning off the pump motor will not relieve pressure from system. The above procedure must be followed.
FIRE OR EXPLOSION HAZARD:
●Do not use solvents with flash points less than 70°F (21°C) to clean this equipment (examples of acceptable cleaning solvents are water, mineral spirits, lacquer thinner, Xylene and high flash napha. A partial example list of unacceptable cleaning solvents are low flash napha, mek, acetone, alcohol and toluene).
●Use only conductive or grounded
●Verify that all containers and collection systems are grounded to prevent static discharge.
●Do not spray pump assembly.
●Have fire extinguisher equipment present and working.
Do not spray flammable materials in vicinity of
open flame or near ignition
sources. Motors, electrical equipment and controls can cause electrical arcs that will ignite a flammable gas or vapor. Never store flammable liquids or gases in the vicinity of the unit.
Do not spray acids, corrosive materials, toxic chemicals, fertilizers or pesticides.
Using these materials could result in death or serious injury.
●Do not use fuels to clean this equipment.
●Keep spray area well ventilated. Keep a good supply of fresh air moving through the spray area.
●Remove all ignition sources (i.e. Static electricity, pilot lights, cigarettes and electrical arcing).
●Airless spraying can cause static electricity. Always ground the pump and spraying surface. Always use a
●Do not use paints or solvents containing halogenated hydrocarbons such as methyl bromine, carbon tetrachloride, and ethyl iodine.
Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and replace if damaged.
●Check hoses for weak or worn condition before each use, making certain that all connections are secure.
●Keep area clean and free of paint or solvent containers, rags, and other flammable materials.
To reduce the risk of injury:
●Do not spray acids,
corrosive materials, toxic chemicals, fertilizers, or pesticides. Using these materials could result in death or serious injury.
●Do not kink or
●Do not expose the hose to temperatures or to pressures in
excess of those specified by the manufacturer.
●Do not use the hose as a strength member to pull or lift the equipment.
●Always wear appropriate gloves, eye protection, and a respirator or mask when painting.
●Always work in a clean environment. Do not aim the spray gun at any dust or debris.
●Do not operate or spray near children. Keep children, pets, and visitors away from equipment and work area at all times.
●Do not over reach or stand on an unstable support. Keep effective footing and balance at all times.
●Stay alert and watch what you are doing.
●Do not operate the equipment when fatigued or under the influence of drugs or alcohol.
Failure to follow these instructions can result in serious injury including death.
www.chpower.com
5