Operating Instructions

SN338K00

Operating Instructions (Continued)

LOADING/UNLOADING THE TOOL

1. Always disconnect the tool from the air supply before loading fasteners.

2. Push

Latch

down on

Button

the latch

 

 

button.

 

 

Pull back

 

 

 

 

on the

 

 

magazine

 

 

cover.

 

 

3. Load a clip of staples with the crowns straddling the magazine rail.

Magazine Rail

4. Push the magazine cover forward until latch button pops up.

5.Always unload all fasteners before removing tool from service. Unloading is the reverse of loading, except that you must disconnect the air supply before unloading.

ADJUSTING THE FASTENER

PENETRATION

The tool is equipped with an adjustable depth of drive feature. This allows the user to determine how deep a fastener will be driven into the work surface.

1.Adjust operating pressure so nails are driven consistently. Do not exceed 100 psi.

2. To drive the nail shallower,

turn the

wheel (C) (C) to right to

the extent desired.

3. To sink a nail deeper, turn the wheel

(C) to left to the extent desired.

4.Make sure trigger and work contact element (WCE) move freely up and down without binding or sticking after each adjustment.

ADJUSTING THE DIRECTION OF THE EXHAUST

The tool is equipped

 

with an adjustable

 

direction exhaust

 

deflector. This is

 

intended to allow

Rotate

the user to change

 

the direction of the exhaust. Simply twist the deflector to any direction desired.

User - Maintenance

Instructions

CLEARING A JAM FROM THE TOOL

1. Disconnect the air supply from the tool.

2. Remove all fasteners from the magazine (see Loading/ Unloading). Failure to

do so will cause the

nails to eject from the front of the tool.

3.Loosen cap screws on nose of tool. Slide nose downward and remove from tool to expose jammed fastener.

4.Reinstall nose assembly in reverse order in Step #3.

5.Make sure the trigger and Work Contact Element (WCE) move freely up and down without sticking or binding.

TECHNICAL SERVICE

Please call our Tool Hotline at 1-800- 543-6400 with any questions regarding the operation or repair of this tool or for additional copies of this manual.

FASTENER AND REPLACEMENT PARTS

Use only genuine Campbell Hausfeld

18 gauge fasteners (or equivalent - see Fastener Interchange Information). Tool performance, safety and durability could be reduced if improper fasteners are used. When ordering replacement parts or fasteners, specify by part number.

TOOL REPAIR

Only qualified personnel should repair the tool and they should use genuine Campbell Hausfeld replacement parts and accessories, or parts and accessories which perform equivalently.

ASSEMBLY PROCEDURE FOR SEALS

When repairing a tool, the internal parts must be cleaned and lubricated. Parker O-lube or equivalent must be used on all o-rings. Each o-ring must be coated with O-lube before assembling. A small amount of oil must be used on all moving surfaces and pivots. After reassembling, a few drops of 30W non-detergent oil or equivalent, must be added through the air line before testing.

STORAGE

The tool should be stored in a cool dry place.

www.chpower.com

6