![](/images/backgrounds/240656/bg3.png)
– 3 –
IN230000AV
Operation (Continued)REGULATOR
QUICK
CONNECTOR
(OPTIONAL)
AIR
HOSE
LEADER
(WHIP)
HOSE
QUICK
COUPLER
DO NOT INSTALL A
QUICK COUPLER HERE
REGULATOR
QUICK
COUPLER
(OPTIONAL)
OILER
FILTER
QUICK
CONNECTOR
DRAIN (WATER TRAP)
AIR SUPPLY
Figure 2 - Air Hose Hook-up
AIR TOOL MANUFACTURERS RECOMMEND THAT AN AIR FIL-
TER AND OILER BE USED TO INCREASE THE LIFE OF THE TOOL.
MODELS TL1002, TL1017 AND TL1049
Specifications & PerformanceMODEL AVERAGE MAX MAX AIR EXTENDED
# SCFM & PSI RPM TORQUE INLET DRIVE WEIGHT ANVIL
TL1002 5.1 @ 90 7000 230 ft/lb 1/4" NPT (Female) 1/2" Sq 5 lb NA
TL1017 2.4 @ 90 10,000 75 ft/lb 1/4" NPT (Female) 3/8" Sq 2 lb N/A
TL1049 2.5 @ 90 10,000 75 ft/lb 1/4" NPT (Female) 3/8" Sq 3 lb NA
SPEED ADJUSTMENT
The impact wrench should never be used to set torque.
Use a torque wrench to set the torque. Models TL1002,
TL1017 and TL1049 are equipped with regulators for
speed adjustment (See Figure 2).
To remove nuts, set the regulator to the maximum
setting. To install nuts, set the regulator to the minimum
to medium setting. Do not overtighten the nuts.
AIR HOSE
Figure 2 illustrates a recommended air hose hook-up.
NOTE: It is not recommended to install a quick coupler
between the impact wrench and the leader (whip) hose
(See Figure 2).
Using fittings or air hoses which are too small can create
a pressure drop and reduce the power of the tool. For
models TL1002, TL1017 and TL1049, using 3/8" (I.D.)
fittings with 1/4" NPT threads are recommended. Most
compressors are shipped with a short, 1/4" I.D. hose.
For proper performance and more convenience, use a
3/8" I.D. hose. Hoses longer than 50 feet should have a
1/2" I.D.
NEVER CARRY A TOOL BY THE HOSE OR PULL
THE HOSE TO MOVE THE TOOL OR A COMPRES-
SOR. KEEP HOSES AWAY FROM HEAT, OIL AND
SHARP EDGES. REPLACE ANY HOSE THAT IS
DAMAGED, WEAK OR WORN.
STORAGE
The impact wrench must be lubricated before storing.
Follow the air motor lubrication instructions with an
exception to step 4. Only run the impact wrench for 2
to 3 seconds instead of 20 to 30 seconds because more
oil needs to remain in the impact wrench when storing.
Technical ServiceFor information regarding the operation or repair of this
product, please call 1-800-543-6400. If you are calling
from Ohio or outside the continental United States,
please call collect, 1-513-367-1182.
AIR INLET (OIL HERE
DAILY IF NOT USING
AN AIR TOOL OILER)
WARNING
!!