Fig. 2 |
Technical data |
| SETTING UP + INSTALLATION | |
1 | Remove the polystyrene base and place the machine near | |
| its permanent position (diagram 1). | |
| Carefully cut through the hose retaining clip at the rear of | |
| the appliance (diagram 2). | |
| Unscrews the two top screws A and remove the cover, | |
| sliding it off horizontally (diagram 3). | |
2 | Remove the cardboard protection. | |
Unscrews the two tie braces B on the crosspiece (with an H. | ||
| ||
| 19 spanner) and remove the polystyrene spacers under it |
(diagram 4).
Please do not fit the 2 tie braces B again!
IMPORTANT: DO NOT REMOVE THE SPACERS ABOVE THE CROSSPIECE.
Replace the cover with the two screws A.
Please ensure when fitting the table top the locating pins are inserted correctly in their slots, positioned on the side of the cabinet as shown in the diagram 5.
■ Max. load of dry laundry | 3,5 kg | |
■ Water pressure | 0,05 ÷ 0,8 MPa | |
■ Spin speed | ||
1000 rpm | ||
Measurements |
| |
■ Width | 51 cm | |
■ Depth | ||
43 cm | ||
■ Height | ||
70 cm | ||
|
3 |
A |
4 C | B | 5 |
NB: For specifications regarding electrical data, see the data panel on the front of the washing machine (porthole area) - as shown in diagram above.
WARNING:
DO NOT LEAVE THE PACKAGING WITHIN REACH OF CHILDREN AS IT IS A POTENTIAL SOURCE OF DANGER.
EC Appliance complies with European Directive 89/336/EEC, 73/23/EEC and subsequent amendments.
Apply the insulation sheet of corrugated material to the base as shown in the relevant diagram.
Level the machine by means of the front feet.
a)Turn the nut clockwise to release the screw adjuster on the foot.
b)Rotate the foot to raise or lower it until it stands firmly on the ground.
c)Lock the foot in position by turning the nut
A |
B |
C |
22 | 23 |
