Note: we recommend you keep the transit bracket, braces and screws to immobilise the machine for future transit.

The Manufacturers will not be responsible for any possible damage to the machine caused by not following the rules relating to releasing the mechanism. The user is responsible for all costs of installation.

Note: it is advisable to turn off the tap after each wash to isolate the washing machine from the water supply.

For the washing machine to function properly the terminal end of the discharge hose (mouth) must be at a minimum of 50 cm and a maximum of 85 cm from the ground.

ELECTRICAL CONNECTIONS

After installation, the appliance must be positioned so that the plug is accessible. If the plug we supply does not fit

Water connection

The appliance must be connected to the water mains using new hose-sets.

The old hose-sets should not be reused.

Your machine may either be plumbed in or connected to existing taps, using a tap adaptor with a 3/4 B.S.P. threaded end connection. The water supply hoses to be found inside the drum are terminated in two different ways. One end which has a 90° elbow is to be connected to the appliance water connection E while the straight end is to be connected to the domestic supply tap. The hose with the white collar should be connected to the cold tap, and the hose with the red collar to the hot tap. The appliance is not suitable for use with mixer taps.

E

COLD

WATER

HOT

WATER

CUT IT OFF AND DESTROY IT!

You can’t use it on other appliances, and the exposed wires could be dangerous if plugged in. To fit a replacement plug, proceed as follows:

Connect

to the terminal in the plug

 

green and yellow wire

marked with the letter E,

 

 

OR marked

 

 

with the symbol,

 

 

 

 

 

 

 

OR coloured green,

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

OR coloured green and yellow.

 

blue wire

marked N

 

 

OR coloured black.

 

brown wire

marked L

 

 

OR coloured red.

 

WARNING

This appliance must be earthed

 

min 4 cm

cm

+2,6 mt max

100

max 85 cm

max

 

min 50 cm

Fuses and plugs

This appliance should be used only on a socket with a minimum rating of 13 Amp.

Our ready-fitted plug is already equipped with a 13 amp fuse which is BS 1362 ASTA approved. Any replacement should be exactly the same.

If the fuse cover is lost, do not use the plug until it is replaced. A correct replacement fuse cover (obtainable from your local retailer) must be the same colour as shown or named on the insert on the base of the plug.

26

27