| Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is | |
| fastened tightly in place. | |
| If the water pipes are new or have not been used for an extended period of time, let the water | |
| run to make sure t hat the water is clear and free of impurities. If this precaution is not taken, | |
| there is a risk that the water inlet can get blocked and damage the appliance. | |
|
| |
| The water supply to the appliance can also be connected to the house hot water line | |
| (centralized system, heating system),as long as it does not exceed a temperature of 60 C. | |
Con nector of ModelⅡ | In this case, the wash cycle time will be shortened by about 15 minutes and the wash | |
efficiency slightly reduced. | ||
| ||
| The connection must be made to the hot water line following the same procedures as those | |
| for the connection to the cold water line. |
Position the appliance in the desired location. The back should rest against the wall behind it, and the si des, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to
facilitate proper installation.
Once the appliance is positioned,adjust the feet (screwing them in or out) to adjust the height of the dishwasher, making it level. In any case ,the appliance should not be inclined more than 2 .
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into the sink, making sure to avoid bending or crimping it. Use the special plastic support that comes with the appliance. The free end of the hose must be at a height between 40 and 100cm and must not be immersed in water.
If the sink is 34 or higher from the floor, the excesswater in Unicouple hoses cannot be drained directly into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable container that is heldoutside and lower than the sink.
450
DIMENSIONS(mm)
850
580
1135
11
