SETTING UP + INSTALLATION

Note: we recommend you keep the screws to immobilise the machine for future transit.

1

2

3

Remove the polystyrene base and place the machine near its permanent position (diagram 1).

Carefully cut through the hose retaining clip at the rear of the appliance (diagram 2).

Remove the 2 or 4 fixing screws marked (A) and remove the 2 or 4 spacers marked (B) (diagram 3).

Cover the 2 or 4 holes using the caps provided in the instruction booklet pack (diagram 4).

4

The Manufacturers will not be responsible for any possible damage to the machine caused by not following the rules relating to releasing the mechanism. The user is responsible for all costs of installation.

Water connection

The appliance must be connected to the water mains using new hose-sets.

The old hose-sets should not be re-used.

The machine has an inlet hose with 3/4" B.S.P threaded end connection to attach between the threaded connector on the appliance and the cold water supply.

This machine only uses cold water, therefore only one hose is needed to connect to the cold water supply. Do not connect to the hot supply. Cold fill is an energy efficient system. Only the water required for the washing is heated.There is no loss of heat in the pipeline from a hot

WARNING:

DO NOT LEAVE THE PACKAGING WITHIN REACH OF CHILDREN AS IT IS A POTENTIAL SOURCE OF DANGER.

Apply the insulation sheet of corrugated material to the base as shown.

water tank or boiler to the machine.

min 4 cm

Use the 4 feet to level the machine with the floor:

 

a) Turn the nut clockwise to release the screw adjuster on the foot.

A

b) Rotate the foot to raise or lower it until it stands firmly on the

ground.

B

c) Lock the foot in position by turning the nut

anti-clockwise until it comes up against the bottom of the machine.

 

C

max 100 cm

+2,6 mt max

min 50 cm max 85 cm

28

29