4 Adjust the document guides to fit the width of the document to be scanned.

5 Place the document.

After placing the document, align the document guides with both edges of the document.

IMPORTANT

•When placing documents into the feed tray, take care not to cut your hand on the edges of the paper.

•Make sure that the document does not exceed the loading limit

marks ( ) on the document guides. Up to 60 pages of ordinary plain paper (80 g/m2) can be loaded at the same time.

•Before you place a document, check to make sure it does not contain paper clips, staples, or other small metal objects. These items may cause a fire or electrical shock, damage the document, or cause a paper jam or scanner malfunction.

•Do not wear loose clothing or jewelry that may get caught in the scanner while you are using it, as this may result in personal injury. Be extra careful of neckties and long hair. If anything gets caught in the scanner, immediately turn OFF the power switch, and disconnect the power cord from the power outlet to stop scanning.

•Always smooth out any folds or curls in your documents before placing them into the feeder. If the leading edge of a document is curled, it may cause a paper jam.

•If feeding stops due to a system error or paper jam while the scanner is scanning, resolve the problem, make sure that the scanned image of the last page that was successfully fed has been stored, and then resume scanning the remaining document pages.

•After you finish scanning, close the document eject tray to prevent damage to the scanner while it is not being used.

When scanning a document one page at a time (Bypass mode)

When scanning a thick document one page at a time or scanning a document that has multiple pages fastened together, set document feeding to bypass mode. This enables the placed document to be scanned without the pages being separated, regardless of the number of pages.

Bypass mode switching is performed by opening the scanner driver settings screen. This section describes how to operate the CapturePerfect software included with this scanner.

1 Start CapturePerfect. (See p. 49)

2 Open the settings screen for the scanner driver. (See p. 49)

3 Open the [Feeding] Tab.

27