Network Connection

Wireless Connection

aPreparation for Connection

Before Starting Wireless Connection Setup

1.Make sure that the printer is turned on.

If the power is on, the LED (Light Emitting Diode) is lit as shown in the illustration below.

Notes on Wireless Connection

•Make sure that the computer is connected to the access point (A) (or wireless network router) you want to connect your printer to.

•The confi guration, router functions, setup procedures and security settings of the network device vary depending on your system environment. For details, refer to the manual of your network device or contact its manufacturer.

•Check if your device supports IEEE802.11n, 802.11g or 802.11b.

•If your device is set to the "IEEE802.11 n only" mode, WEP or TKIP cannot be used as a security protocol. Change the security protocol for your device to something other than WEP and TKIP or change the setting to something other than "IEEE802.11 n only."

•For offi ce use, consult your network administrator.

•Take added care when connecting to a network that is not protected with security measures, as there is a risk of disclosing data such as your personal information to a third party.

•An "Ad-hoc connection," which establishes a direct connection to the computer over a wireless connection without an access point, is not supported. Be sure to prepare an access point.

bPrinter Setup

1.Press and hold the Maintenance button (A) on the printer (for about 5 seconds).

2. Make sure that the LED fl ashes as shown in the illustration below.