116
Cleaning the CMOS Imaging Element
●Never disconnect the camera power during cleaning. If the power is cut off, the
shutter will close and possibly damage the shutter curtain.
●Use a blower without a brush attached. Using a brush to remove dust from the
image element can damage the element.
●Do not insert a dust blower into the camera beyond the lens mount. If the power
shuts off and the shutter closes, this may damage the shutter curtains.
●Never use cleaning sprays or blower sprays. The pressure and freezing action
of the spray gas may damage the surface of the imaging element.
5Select [1: Enable].
●Turn the < > dial to select [1: Enable],
then press the < > button.
➡The message “ ” appears on the
LCD panel.
●If “ ” is blinking on the LCD panel, set the
Main Switch to <OFF> and remove the
battery pack. Then repeat the procedure
from Step1.
6Press the shutter button down
fully.
●The reflex mirror of the camera then flips
up, and the shutter opens.
7Clean the imaging element.
●Carefully blow any dust off the imaging
element using a commercially available
blower.
8Finish cleaning.
●Set the Main Switch to <OFF>.
➡The camera power turns off, the shutter
closes and the mirror is lowered.
●Set the Main Switch to <ON> again, and
the camera will be ready to shoot pictures
normally.