3Cleaning the CMOS sensorN

The image sensor is like the film in a film camera.If any dust or other foreign matter adheres to the image sensor, it may show up as a dark speck in the images. To avoid this, follow the procedure below to clean the image sensor. Note that the image sensor is a very delicate component. If possible, you should have it cleaned by a Canon Service Center.

While you clean the image sensor, the camera must be turned on. Using the AC Adapter Kit ACK-DC20 (optional, see page 158) is recommended. If you use a battery, make sure the battery level is sufficient. Before cleaning the sensor, detach the lens from the camera.

1

2

Install the DC Coupler (p.24) or a battery and set the power switch to <1>.

Select [Sensor cleaning].

¡Select the [b] tab.

¡Press the <V> key to select

[Sensor cleaning], then press <0>.

sIf you are using a battery with sufficient power, the screen shown in step 3 will appear.

¡If the battery is exhausted, a warning message will appear and you will not be able to proceed further. Either recharge the battery or use a DC coupler and start from step 1 again.

3 Select [OK].

¡ Press the <U> key to select [OK],

then press <0>.

sIn a moment, the mirror will lockup and the shutter will open.

s“CLEA n” will blink on the LCD panel.

39