Press the START Button to start cleaning.
Pull the Eject Stopper.

Cleaning with the Cleaning Cards (U.S.A. Only)

If a black stripe appears on the back-side of scanned images or if dirt appears on the paper documents upon scanning or for preventative measures, we recommend that you clean your Canon CR-Series scanner as needed with a cleaning card. Using a cleaning card will minimize the frequent cleaning as instructed in this manual.

It is best to perform a cleaning at beginning or end of the day. A cleaning card does not clean the ink jet nozzles, so please remove the ink cartridge and perform a nozzle cleaning (See “Cleaning the Ink Jet Nozzles” on p. 19.)

IMPORTANT

•This operation is for U.S.A. Cleaning cards are available only in U.S.A.

•Contact your local authorized Canon dealer or service representative for the available cleaning card.

1 Turn OFF the scanner.

2 Disconnect the scanner and the computer.

3 Turn ON the scanner with pressing the START Button and the STOP Button.

NOTE

If the scanner turned ON properly, the power LED continues to flash.

4

5 Place the cleaning card in the document tray.

6

7 Please repeat steps 5 and 6.

A typical cleaning is feeding the cleaning card 3 to 7 times. If the scanner is extremely dirty, you may need to use another cleaning card.

8 Turn OFF the scanner.

9 Connect the scanner and the computer.

NOTE

•You cannot scan the document without the computer.

•Allow 1 to 2 minutes for the moisture on the Canon CR-Series scanner from the cleaning card to thoroughly dry before scanning documents.

20