9)Tube set up (MP500 ONLY)
a)Attach the two black clips as pictured below. The clips have a piece of double sided tape attached, simply remove the backing and attach. This will prevent the scanner lid from crushing the silicone tubing.
b) Run the tubing as per the following photographs
c)Adjustments to the tube length may be required. To check this, move the cartridge holder left and right to each end of the printer. It should reach both ends with ease. Check that the tubing is neither too long nor too short. The tubing must not interfere with the printer data wire nor should it fall down into the paper support or cause any interference to the head movement.
d)If required, adjust the tube length by gently pulling the silicone tubing in the direction required. DON’T HAVE THE TUBING FITTED TOO TIGHTLY.
17