Mobile PDA Cradle |
|
Introduction |
This installation manual has been prepared to provide the basic information needed to install this product. This manual is not intended to be definitive, because there are different models and types of vehicles which will require different installation work. The information given is for general guidance only.
The terms of warranty demand that this mobile PDA cradle is installed by an experienced installer. An
Note: Thoroughly read the manual before beginning the installation procedure.
WARNINGS
1.Ensure that the vehicle’s battery is disconnected before you start the installation procedure and that it remains disconnected during the procedure.
2.Do not smoke or use open flames when working near the vehicle’s fuel system.
3.Ensure that the vehicle’s electrical cables, hydraulic lines, fuel lines and safety equipment are not damaged during the installation.
4.Ensure that normal control and operation of the vehicle is not obstructed by the installation,particularly the brakes and steering. Ensure that airbag operation is not obstructed.
5.Electronic and other sophisticated systems (for example speed control, ABS
6.The mobile PDA cradle is suitable for use only in vehicles with a 12V negative grounding. Use on other supply voltages or alternative polarity will damage the equipment.
7.The PDA should not be left switched on for extended periods without running the vehicle’s engine. Failure to comply could drain the vehicle’s battery.
Before starting the installation of the mobile PDA cradle please check if the following contents are present :
-Mobile PDA Cradle
-Rotating Swivel
-Window Mount
-Suction Cup
-Fuse Holder cable with fuse
-Screw sets
-Surface cleaner
-Manual
Compatible devices
HTC P4350
Safety-Mount® pattern
© Copyright Carcomm International BV 2006. Subject to change without previous notice. All used brandnames are owned by their respective owners
www.carcomm.nl 1
