Page 3 of 4 |
MOUNTING
The unit is waterproof and may be located under hood in the engine compartment or other areas. Allow clearance for wiring. Inspect behind mounting area for clearance.
ELECTRICAL CONNECTIONS
Electrical connections to the unit are made using butt splices (not supplied). The butt splices need to be waterproof when unit is mounted under hood or other weather susceptible areas. A label on the unit identifies each lead function. The power supply of the unit must be capable of delivering peak currents up to 50 amps for adequate short circuit protection and reliable operation. The unit is provided with an
Failure to adequately crimp splices can result in improper operation or burning the wire.
Wire Size and Termination - The diagram shows the minimum wire size used for each connec- tion, along with recommended lead color. If the wire is longer than 15 ft. use the next larger wire size. Use only high quality crimp connectors for installation on the vehicle.
NOTE: Permanent disconnection of the vehicle horn is NOT recommended.
Amplifier Power
Connection Examples
Assumes Power is +VDC
May be powered with
Momentary
SPST
Switch
+VDC
To Amp POS
HORN RLY
+VDC
Added
SPDT
Switch
Vehicle
To Horn
Amp POS
Horn Vehicle
Circuit Horn
Splice
+VDC
Added Relay
Note:
Vehicle horn To Amp POS will also sound
#16G BLK to
Match lead colors coming from unit
#16G RED to +VDC
#18G BRN
#18G BRN
Waterproof butt splices for under hood install
Automotive Type Fuse
OPERATION
As soon as power is applied, the unit produces a simulated air horn sound and the power indica- tor lights up. The power indicator is located on the same surface where wires emerge from unit.
CP5050A | 01/27/10 |