AMPLIFIER ELECTRICAL CONNECTIONS
Disconnect vehicle battery before making the following electrical connections.
Electrical connections to the amplifier are made using the wiring harness supplied. If the amplifier needs service the connector can be easily removed without unwiring the harness. The power supply for the amplifier must be capable of delivering peak currents up to 50 amps for adequate short circuit protection and reliable operation. The preferred source is directly at the vehicle battery. A fuse on the unit protects from overload.
Wire Size and Termination - The diagram shows the minimum wire size used for each connection. If the wire is longer than 10 ft. use the next larger wire size. Use only high quality crimp connectors for installation on the vehicle.
Negative Connection (Black) - Both leads must be used. Connect to negative battery connector or high current buss.
Positive Connection (Red) - Both leads must be used. Connect to positive battery connector or high current buss. A power relay may be used.
Speaker Connection (Brown) - Both leads must be used. Connect 1 lead to each terminal or lead of the speaker. When used with 2 speakers connect each brown lead to both speaker terminals or leads (parallel circuit). Observe polarity (phasing) when connecting 2 speakers.
Control Connection (White) - Connect to white lead from control head. Route this lead away from radio transmitter antenna lead to prevent RF interference being fed to the siren amplifier.
Optional Radio Input Connection (Blue) - Connect 1 lead to each terminal of the radio speaker or output connector. The input is isolated and polarity is not important. May need to set RADIO VOLUME ADJUST on side of unit.
#14 AWG RED Use both leads Extend with #12
+
BAT
-
#14 AWG BLK Use both leads Extend with #12
(2)#18 AWG BRN (#16 - 2 SPKR)
2 - SPKR - Connect for same phase (+ to +)
RADIO |
| CP2560 |
|
| |
(2) #18 AWG BLU | CABLE | |
Connect to output |
| |
jack, terminals or |
| |
speaker of radio |
| |
CONTROL | #18 AWG WHT |
|
|
| |
AMPLIFIER WIRING
HARNESS CONNECTIONS
CONTROL HEAD |
| ||
RADIO |
| GRN (AUX) | |
SIREN |
| ||
HORN | YEL (DASH LIGHTS) | ||
VOL | |||
| |||
MAN |
| ||
|
| ||
WAIL | ON | BLK | |
YELP | |||
POWER |
| ||
PHASER | RED (+VDC) | ||
| |||
|
| ||
|
| WHT | |
|
| CONTROL | |
| AMPLIFIER |
| |
|
| 20AMP FUSE | |
BLK TO |
| AUTOMOTIVE TYPE | |
|
| ||
BLU TO TWO WAY |
|
| |
RADIO SPEAKER |
|
| |
BRN TO SPKR |
| RED TO +VDC | |
TB0333B | Page 5 of 10 | 10/18/03 |
